8
C. On your router, press the WPS button and wait until
the WPS LED begins to flash. The WPS button may look
like one of the icons to the right.
Press WPS Button on Router
Press WPS Button on DCCK Device
Within two minutes of activating WPS on your router,
press and hold the WPS button on the DCCK device
until the WLAN LED on the DCCK flashes green
(approximately 2 seconds).
connection
NOTE 3: During WPS configuration, the DCCK device should be powered on, but not connected to the DIRECTV
®
Receiver.
or
To Next Page
Loading...