10
DIRECTV
®
HD DVR RECEIVER USER GUIDE
Mode Switch
YOUR REMOTE CONTROL
These two buttons turn your TV and DIRECTV
®
Receiver
on or off together. If your DIRECTV
®
System was installed
professionally, your remote has already been programmed
to operate your TV. If you need to reprogram the remote for a
new TV or other audio-visual equipment, press MENU, select
“Settings & Help”, “Settings”, then “Remote Control”. Follow
the step by step instructions.
Use the POWER (PWR) button and Mode Switch to turn a single
component on or off (for example a DVD player or surround
sound system). Simply slide the mode switch to the position
that matches the component you want to control and then use
the POWER button to turn it off or on. The mode switch must
always be in the left-most position to control your DIRECTV
®
Receiver. If the mode switch is in a position that has not been
programmed, or if you press a button that is not supported by
that particular piece of equipment, an onscreen message will
pop up to alert you.
NOTE: Each time you press a button, a green light at the top
of the remote flashes. If the light flashes several times for just
one press, it means the batteries (size AA) are getting low and
need to be replaced.
TURNING YOUR EQUIPMENT ON AND OFF
To Next Page
Loading...
Need help?
General
