4
Remove cover from underside of charging base.
Insert power adapter wire and wrap excess wire
inside base to leave just enough wire for
connection to power outlet.
CONNECT CHARGING DOCK
CHARGING INSTRUCTIONS
u
NOTE: Use cord management to prevent the adapter wire
from winding the robot vacuum during sweep or return.
Locate the charging dock where is it
easily accessible by the robot vacuum
with 5' (1.5M) clearance in front, and
1.5" (0.5M) clearance to each side.
Place it against a wall near a power
source and keep the dock powered for
auto return and charging.
PLACE CHARGING DOCK
v
Align the holes and press gently to x the
side brush on the device
INSTALL SIDE BRUSH
x
Remove the protective strips on both
sides of the front bumper and the
protective lm on the front
BEFORE FIRST USE
w
Place the robot vacuum on the charging dock
and align it with the charging port. When the
white indicator light on the charging dock
goes off, charging will begin.
CHARGING
y U
First press the “ ” for 3 seconds to turn on
the unit. The robot vacuum shall be fully charged
(about 4 hours) to ensure normal operation.
STARTUP
To Next Page
Loading...
