Remove cover from underside of charging base.
Insert power adapter wire and wrap excess wire
inside base to leave just enough wire for
connection to power outlet.
CONNECT CHARGING DOCK
UNIT SET-UP
u
ADDING DEVICE
NETWORK CONNECTION
NOTE: Use cord management to prevent the adapter
wire from winding the machine during sweep or return.
Place the machine on the charging dock and align it
with the charging port. When the white indicator light
on the charging dock goes off, charging will begin.
CHARGING
U
Locate the charging dock where is it easily accessible
by the robot vacuum with 5' (1.5M) clearance in
front, and 1.5" (0.5M) clearance to each side. Place
it against a wall near a power source and keep the
dock powered for auto return and charging.
PLACE THE CHARGING DOCK
v
Align the holes and press gently to x the
side brush on the device
INSTALL SIDE BRUSH
x
Remove the protective strips on both
sides of the front bumper and the
protective lm on the front
BEFORE FIRST USE
w
For the rst use, toggle the rocker switch to “I” to
turn on the device. The machine shall be fully
charged (about 4 hours) to ensure normal operation.
STARTUP
y
To Next Page
Loading...
