t Reflex Duplicator Manual
- 23 -
Make sure the cursor is located at the first position:
i. Press “DOWN“ button consecutively until “F“ is
displayed.
ii. Press “ENT“ button once to move the cursor to the
next position.
iii. Press “DOWN“ button consecutively until “U“ is
displayed.
iv. Press “ENT“ button once to move the cursor to the
next position.
v. Press “DOWN“ button consecutively until “N“ is
displayed.
vi. Press “ENT“ button once to move the cursor to the
next position.
vii. Now, we have the name “FUN“ displayed and
then, press “ENT“ consecutively until the cursor is
moved to “OK“.
viii. Then, press “ENT“ once to submit your name
selection.
e. Now you shall see the following confirmation screen:
f. Press “ENT“ button to confirm. Once your master disc has
been recognized. The loading progress indicator will be
displayed and you shall see the following
Load Partition?
[FUN ], OK?
t Reflex Duplicator Manual
- 24 -
g. Once your master disc has been loaded completely, you
shall see the following:
Then, you can press “ENT“ button to go back to the
Image ñ Load Partition Menu.
Tutorial Guide:
VI. Rename Existing Hard Drive Partition Name
When you load your master disc to a hard drive partition,
you are asked to give it a name. However, if you donít like
the name you entered before, you can rename it at anytime
afterwards. To rename your existing hard drive partition
name, please do the following:
1. Use UP or DOWN arrow button to navigate to the
following screen.
2. Press “ENT“ and use UP or DOWN arrow button to
navigate to the following screen
To Next Page
Loading...