t Reflex Duplicator Manual
- 29 -
Tutorial Guide:
Tutorial Guide
VIII. Change the SETUP settings
Most of the internal settings and information is stored inside
the SETUP menu. To explore and modify them is simple.
Below is an example to modify the “Auto Start“ setting.
Please note that the default setup is set for optimal
performance of the duplicator, it is unnecessary to change if
you are satisfied with the outcome.
1. Use UP or DOWN arrow button to navigate to the
following screen.
2. Press “ENT“ and use the UP or DOWN arrow buttons
to navigate to the following screen:
3. Press “ENT“ to enter Auto Start Setting Menu and you
shall see the following:
4. Use UP or DOWN arrow button to modify the setting to
“Full“ and then press “ENT“ to submit your selection
and you shall see the following:
DISCMAKERS 1.12
5.Setup
Setup
10. Auto Start
uto
t Reflex Duplicator Manual
- 30 -
5. If you would like to modify more settings, then please
go back to step 3. Otherwise, press “ESC“ button to
bring you back to main menu.
NOTES
To Next Page
Loading...