t Reflex Duplicator Manual
- 21 -
Tutorial Guide:
V. Load Master Disc onto the Hard Drive
In order to copy from the Hard Drive, you are required to load
your master disc onto a hard drive partition.
The number of partitions is determined by dividing your Hard
Driveís total capacity by 1GB for CD format, 5GB for DVD-5
format or 9 GB for DVD-9 format (Double Layer) and subtracting
one partition for system use.
For example, if you have a 40GB Hard Drive, you can calculate
the number of DVD-5 format partitions by: 40 / 5 = 8. Since there
is 1 partition reserved for the system use, you will have 7
partitions to use.
To load your master disc onto a hard drive partition, please do
the following:
1. Load your master disc onto the Hard Drive.
a. Press the “Load“ hot key or scroll to Image to
navigate to the following screen.
b. Press “ENT“ to enter Load Partition Menu and you
shall see the following:
Select HDD as source
OK?
t Reflex Duplicator Manual
- 22 -
c. Now, you have a choice to load your master disc
into a new (empty) partition or overwrite one of the
existing partitions if any exists. You can simple
press UP or DOWN arrow button to select your
partition and press “ENT“ to submit. You will see
the following:
d. Now, you can name the partition you are about to
load into the Hard Drive. To enter the name, you
need to use UP or DOWN button to select the
character and use “ENT“ or “ESC“ button to move
the cursor position and once youíve finished, move
the cursor to “OK“ and press “ENT“. For example,
if I want to name the partition of your master disc
as “FUN“. Then do the following:
To Next Page
Loading...