t Reflex Duplicator Manual
- 17 -
*** To ensure the duplication quality, for certain models, you
are not allowed to adjust the duplication speed for DVD to
DVD to greater than 6x duplication speed. To achieve
maximum duplication speed, you need to perform
duplication tasks from the Hard Drive. For detailed
instructions, please refer to “Tutorial Section II - Make Hard
Drive-to-Disc Copies.“
5. Select Desired Duplication Speed.
Once you have submitted the duplication speed type, you
shall see the following:
You can press UP or DOWN button to select the desired
speed and then press “ENT“ to submit your speed selection.
6. Once your selection has been changed successfully,
you shall see the following screen for 2 seconds.
Then you will be directed back to the Setup sub-menu:
7. Press ESC twice to return to Main Menu
CD to CD Speed:
16x
CD to CD Speed:
CD to CD Speed
t Reflex Duplicator Manual
- 18 -
Tutorial Guide:
IV. Select the Master Reading Source
When you try to make a copy, you need to specify where the
master disc is. Is it in the Reader tray? Or is it an Image
inside the Hard Drive? This tutorial will show you how to
change the Master Reading Source to satisfy your needs.
The two copy methods are:
• Disc-to-Disc copy - This is the case when you would
normally make copies on the fly. You need to set the
“Reader“ as your Master Reading Source.
• Hard Drive-to-Disc copy (if Hard Drive installed) - If you
want to make copies from your Hard Drive Image, you
need to select the source as “Hard Drive“.
There are benefits to copy from Hard Drive:
i. Performance - Duplicating form the Hard Drive will
be able to boost the DVD duplication speed to 8x
or above.
ii. Stability - Duplicating from Hard Drive will stabilize
the duplication process compared to the Disc to
Disc duplicating.
iii. Convenience - With your master discs stored inside
the Hard Drive, you can have access to each one
easily. There is no need to carry your master discs;
they are all stored inside the duplicator.
To Next Page
Loading...