t Reflex Duplicator Manual
- 61 -
duplicator.
9 Reset back to default. ( Troubleshoot #11 )
9 Contact our tech support.
10. Why does my duplicator stay at “System Bootup“?
9 The reason you saw system bootup forever is caused by
improper shutdown. To solve the problem, please
contact our tech support for more information. Even
though this problem can be solved, all the hard drive
information will be lost due to this failure.
t Reflex Duplicator Manual
- 62 -
11. How do I reset my duplicator back to default?
I) Use UP or DOWN arrow button to navigate to the
following screen.
II) Press “ENT“ to enter Setup Menu and you shall see the
following:
III) Use UP or DOWN arrow button to navigate to the
following screen.
IV) Press “ENT“ to enter Load Default Menu and you shall
see the following:
V) Press “ENT“ to confirm and you system will be loaded
back to default. Once the operation is complete, you will
see the following:
To Previous Page
Loading...