Dish Network 4K Joey - Disconnecting Your Cables; Disconnect Receiver and Power Cables

1.
Labeling Your Cables (Cont’d)
2.
Disconnecting Your Cables
c.
Attach the gray label to the cable
connected to the "Power" port.
a.
Disconnect the cables from the receiver being replaced. Only disconnect the cables at
the end connected to the receiver. Do not disconnect the cables from the wall or TV.
b.
Disconnect the power cord from your receiver and wall. A new power cord was
shipped with your 4K Joey, which will be used to power your new receiver.
WallReceiver
POWER
CORD
POWER
CORD