Dish Network 54.0 - Turn On Your Remote; Remove the back cover; Replace the back cover; Open receiver panel and press SYS INFO

You will hear three beeps from the remote
control, indicating it has paired with your
DISH receiver
AUX
input
SAT TV
4 Press the SAT button on the side of the
remote control
3 Open the front panel of your DISH receiver,
and press the SYS INFO button
SYS INFO
2 Replace the back cover
PULL
54.0
1 Remove the back cover by pushing the latch
upward, and remove the PULL tab
Turn On Your Remote