RT80Q Operator’s Manual Drill - 125
Prepare Jobsite and Equipment
CMW
Prepare Jobsite and Equipment
Approach Trench (1)
1. Mark path where you intend to drill.
2. Dig an approach trench (1) along the
intended bore path.
Target Trench (2)
1. Select a completion point for the drilling project.
2. Dig a target trench (2) across the anticipated completion point.
IMPORTANT: The approach trench
should be at least:
• deep enough for pipe to lay flat
and enter soil at correct angle
• 20’ (6 m) long
• 4” (100 mm) wide
IMPORTANT: The actual length of the target trench depends on soil conditions and length of pipe
sections. Make it deep enough for drill bit to enter slightly above the trench floor.
To Next Page
Loading...
