RT80Q Operator’s Manual Service - 163
100 HOUR
Check Track Tension
Check track tension every 100 hours.
To check:
1. Elevate unit on jackstands or lifting devices
capable of holding the weight of the tractor.
2. Measure tension using one of the methods
below. Track is tensioned correctly when:
• there is a 1/4” gap between the tracks and
the middle rollers,
• or when grease pressure is 1400-1600
psi.
To adjust:
1. Loosen bolts on each cylinder end (2).
2. Pump MPG into zerk (1) until track is correctly tensioned.
3. Tighten bolts on cylinder end (2).
Check Track Hub Bolts
Check track hub bolts. Tighten to 295 ft•lb (400
N•m).
t33om035w.eps
t33om082w.eps
To Next Page
Loading...
