Controls - 26 SK752 Operator’s Manual
Controls
4. Ignition switch To start engine, insert key and
turn clockwise.
To stop engine, turn key
counterclockwise.
IMPORTANT:
• If engine does not start or stalls,
turn key to STOP and then
restart.
• Do not allow starter motor to run
continuously for more than 20
seconds.
5. Lift arm control To move lift arms down, push.
To float, push forward to end.
To move lift arms up, pull.
To curl attachment up, move
to left.
To curl attachment down,
move to right.
IMPORTANT: Exercise caution when
lifting loads. See page 79 for
operating capacities.
6. Attachment drive
control
To engage attachment drive
in reverse, lift lever lock and
push forward.
To engage attachment drive
in forward, lift lever lock and
pull back.
IMPORTANT:
• Lever lock engages when control
is in neutral.
• Use foot pedal to hold attachment
control in the on position when
hands are busy operating lift arm
or track drive controls.
7. Throttle To increase engine speed,
push.
To decrease engine speed,
pull.
Increasing engine speed also
increases attachment speed.
Item Description Notes
To Next Page
Loading...
