DITEC CROSS8E-E1A - User Manual

IP2012
rev. 2008-12-18
CROSS7E / 8E / 14E - E1A
QUICK REFERENCE
1. ELECTRICAL CONNECTIONS FOR STANDARD INSTALLATION
Before installing the product, carefully read the instructions.
XEL5 XEL2 XEL2
RX
01
4x0,5 mm²
4x0,5 mm²
4x0,5 mm²
C
NO NC
RG58 (max 10 m)
230~
2x1,5 mm²
GOL4-GOL4C
LAMP
TX
01
ANT
E1A
L
N
N
CUWV
12
12 11
0
011
1 568941
GOL4-GOL4C
3x1,5 mm²
Power supply

DITEC CROSS8E-E1A Specifications

General

Power Supply	230V AC
Max Gate Weight	800 kg
Max Gate Length	8 m
Motor Voltage	230V AC
Operating Temperature	-20°C to +55°C
Motor Type	Asynchronous
Safety Features	Obstacle detection
Control Type	Electronic control unit

Summary

Electrical Connections for Standard Installation

Usage with Stop Limit Switch

DIP2=OFF Operation

Configure opening and closing limit switch settings when DIP2 is OFF.

DIP2=ON Operation

Configure opening and closing limit switch settings when DIP2 is ON.

E1 A Standard Setting

DIP Switch Configuration

Details of DIP switch settings for various operational modes like opening direction and radio mode.

Radio Enabling

Radio Enabling Procedure

Step-by-step guide to enable radio transmitters using PRG and CH buttons.

Automatic Closing Setting

TC Time Setting Modes

Explanation of TC time setting states: disabled and enabled.