DiversiTech International Ltd.
Glaisdale Drive East, NG8 4LY
Nottingham United Kingdom
Email sales@pumph.co.uk
Phone +44(0)115 900 5858
12
FOR FURTHER INSTALLATION ADVICE PLEASE CALL THE TECHNICAL SUPPORT HELPLINE ON 0115 900 5858.
The exhaust hose and adaptor must be installed or removed in accordance with the usage mode. For COOL,HEAT(heat
pump type) or AUTO mode must be installed exhaust hose. For FAN, DRY or HEAT (electrical heat type) mode must be
removed exhaust hose.
Your installation location should meet the following requirements:
- Make sure that you install your unit on an even surface to
minimize noise and vibration.
- The unit must be installed near a grounded plug, and the
Collection Tray Drain (found on the back of the unit) must be
accessible.
- The unit should be located at least 30cm (12”) from the nearest
wall to ensure proper air conditioning. The horizontal louver
blade should be at least 50cm (19.7”) away from obstacles.
- DO NOT cover the Intakes, Outlets or Remote Signal Receptor
of the unit, as this could cause damage to the unit.
The energy rating and noise information for this unit is based on the standard installation using an un-extended exhaust duct
(Diameter:150mm, Length:1.5m) without window slider adaptor or wall exhaust adaptor A.
The unit with 3 meters extended exhaust duct is running by using 2 exhaust ducts(Diameter:150mm, Length:1.5m +
Diameter: 130mm, Length: 1.5m) .The Energy rating and noise information for unit with 3 meters extended exhaust duct is
not assessed.(For some models)
NOTE: We recommend that operating the unit at room temperature below 35°C . Since there is a risk that the unit with 3
meters extended exhaust duct would not work at room temperature above 35°C under some extreme conditions, such as
the lower air intake be blocked for 50%.
INSTALLATION
EXHAUST HOSE INSTALLATION
CHOOSING THE RIGHT LOCATION
ENERGY RATING INFORMATION
RECOMMENDED
INSTALLATION
PAC-H-12
To Next Page
Loading...