DiversiTech International Ltd.
Glaisdale Drive East, NG8 4LY
Nottingham United Kingdom
Email sales@pumph.co.uk
Phone +44(0)115 900 5858
3
FOR FURTHER INSTALLATION ADVICE PLEASE CALL THE TECHNICAL SUPPORT HELPLINE ON 0115 900 5858.
Read Safety Precautions Before Operation and Installation To prevent death or injury to the user or other people and
property damage, the following instructions must be followed. Incorrect operation due to ignoring of instructions may cause
death, harm or damage.
This symbol indicates
the possibility of
personnel injury or
loss of life.
This symbol indicates
the possibility
of property
damage or serious
consequences.
• Installation must be performed according to the
installation instructions. Improper installation can cause
water leakage, electrical shock, or re.
• Use only the included accessories and parts, and specied
tools for the installation. Using nonstandard parts can
cause water leakage, electrical shock, re, and injury or
property damage.
• Make sure that the outlet you are using is grounded
and has the appropriate voltage. The power cord is
equipped with a three-prong grounding plug to protect
against shock. Voltage information can be found on the
nameplate of the unit.
• Your unit must be used in a properly grounded wall
receptacle. If the wall receptacle you intend to use is not
adequately grounded or protected by a time delay fuse
or circuit breaker (the fuse or circuit breaker needed is
determined by the maximum current of the unit. The
maximum current is indicated on the nameplate located
on unit), have a qualied electrician install the proper
receptacle.
• Install the unit on a at, sturdy surface. Failure to do so
could result in damage or excessive noise and vibration.
• The unit must be kept free from obstruction to ensure
proper function and to mitigate safety hazards.
• Do not modify the length of the power cord or use an
extension cord to power the unit.
• Do not share a single outlet with other electrical
appliances. Improper power supply can cause re or
electrical shock.
• Do not install your air conditioner in a wet room such as a
bathroom or laundry room. Too much exposure to water
can cause electrical components to short circuit.
• Do not install the unit in a location that may be exposed
to combustible gas, as this could cause re. The unit has
wheels to facilitate moving. Make sure not to use the
wheels on thick carpet or to roll over objects, as these
could cause tipping.
• Do not operate a unit that it has been dropped or
damaged.
• The appliance with electric heater shall have at least 1
meter space to the combustible materials.
• Do not touch the unit with wet or damp hands or when
barefoot.
• If the air conditioner is knocked over during use, turn
off the unit and unplug it from the main power supply
immediately. Visually inspect the unit to ensure there is
no damage. If you suspect the unit has been damaged,
contact a technician or customer service for assistance.
• In a thunderstorm, the power must be cut off to avoid
damage to the machine due to lightning.
• Your air conditioner should be used in such a way that it
is protected from moisture. e.g. condensation, splashed
water, etc. Do not place or store your air conditioner
where it can fall or be pulled into water or any other
liquid. Unplug immediately if it occurs.
• All wiring must be performed strictly in accordance with
the wiring diagram located inside of the unit.
• The unit’s circuit board(PCB) is designed with a fuse
to provide overcurrent protection. The specications
of the fuse are printed on the circuit board, such as: T
3.15A/250V, etc.
• When the water drainage function is not in use, keep the
upper and the lower drain plug rmly to the unit to get
rid of choking. When the drain plug is not in use, keep it
carefully to prevent children from choking.
SAFETY PRECAUTIONS
WARNING
WARNING CAUTION
PAC-H-12
To Next Page
Loading...