dji A3

A3/A3Pro
User Manual
18
©
2016 DJI. All Rights Reserved.
Pitch
CAN1
Usage
If used with the DJI Lightbridge 2, you can control the gimbal using the gimbal dial on the remote
controller.
If you are not using a DJI remote controller, you will not be able to use the gimbal dial to control
the gimbal.
ParameterConguration
Watch the video tutorial for a brief introduction on how to congure the parameters. Then launch
DJI Assistant 2 and follow the prompts to complete conguration.
DJI
Assistant 2
1
Ensure the ight control system is properly powered on.
2
Connect the Micro USB port on the LED module to a PC via a Micro USB cable.
3
Run DJI Assistant 2. Note that you may be asked to register for rst time use.
4
Follow the prompts to upgrade the rmware to the latest version.
5
Select the airframe type.
6
Congure the IMU and GPS mounting parameters.
7
Select the receiver type and congure the channel mapping.
8
Make sure the motors are rotating in correct direction. If not, change the rotating direction.
9
Congure the function channels.
10
Fly in the simulator to check that all functions is working normally.