4
©
2020
DJI All Rights Reserved.
EN
Overview
Spread Tank
Spreader
Spinner Disk
Spreader Lock Knob
Cable
Installation
A hex key for M3 screws is required for installation.
1. Mount landing gear leg extenders when using with an Agras MG-1S aircraft.
a. Remove the eight M3×6 screws in the lower section of the two landing gear legs and remove
the two landing skids.
b. Mount the four landing gear leg extenders to the original landing gear legs. Make sure to
align the screw holes before inserting and tightening the eight M3×6 screws.
Introduction
The MG Series Spreading System is compatible with Agras MG series aircraft and offers efficient,
reliable, and stable spreading operations. The material delivery system is precisely controlled by the
built-in stirring device and hopper gate, which can prevent material blockages and improve operating
accuracy and reliability.
Use the app compatible with your aircraft to set parameters such as the hopper outlet size and
spinner disk rotating speed. These parameters can be adjusted to meet different requirements. The
app provides warning prompts for an empty tank as well as for abnormalities in the rotating speed,
temperature, and hopper outlet size. These prompts help ensure system safety.
The Spreading System has two versions, 1.0 and 2.0. They each have a different structure for the
spinner disk. Compared with the Spreading System 1.0, the Spreading System 2.0 has a higher
material delivery rate and can spread materials 360° around the aircraft. Unless otherwise specied, the
descriptions in this document use the Spreading System 1.0 as an example.
In the Box
Spreading System × 1
Spare Spinner Disk × 2
Landing Gear Leg
Extender × 4
Screw Pack
M3 × 6
Users have the option to purchase a fender with a screw pack to use with the Spreading System 2.0.
To Next Page
Loading...
