controller horizontally
5. . Contact DJI Support to repair the remote controller if damaged. A damaged antenna will greatly decrease
performance.
6. Replacement remote controllers have to be linked to the aircraft. After linking, make sure that the transmission
distance can reach 300 m before using. Refer to the user manual for more information on linking instructions.
7. Fully charge and discharge the internal and external batteries of the remote controller at least once every three
month.
8. Immediately charge the internal or external battery of the remote controller when its power level decreases to
0% to prevent the device being damaged due to over discharge for an extended period. Discharge the batteries
to a power level between 40% and 60% if stored for an extended period.
9. Upon linking an aircraft to a remote controller, any other link the aircraft had to any other controller is dropped.
As such, all aircraft linked to a remote controller that is in Multi-Aircraft Control mode can only be controlled by
that remote controller. To control any aircraft using a different remote controller, that aircraft must be manually
linked to the remote controller using the DJI Agras app.
10. DO NOT cover the air outlet on the remote controller. Otherwise, the remote controller may become too hot,
which could affect its performance.
11. DO NOT obstruct the RTK dongle when used.
Aircraft Body
WARNING
To avoid component malfunction, serious injury, and property damage, observe the following rules:
1. Use the ports on the aircraft body in strict accordance with their specifications.
2. DO NOT short circuit the ports on the aircraft body.
3. Be careful when assembling or cleaning the aircraft as some parts of the aircraft body are sharp
4. For T30: fold the M3 and M5 arms followed by the M2 and M6 arms and make sure that the arms are inserted
into the storage clamps on both sides of the aircraft. Otherwise, the arms may be damaged. Lift and lower the
M1 and M4 arms gently to reduce wear and tear. For T10: fold the M3 and M4 arms followed by the M1 and M2
arms and make sure that the arms are inserted into the storage clamps on both sides of the aircraft. Otherwise,
the arms may be damaged.
5. When using the RTK function, operate in an open environment free from radio interference. DO NOT obstruct
the D-RTK antennas when used.
6. DO NOT obstruct the OcuSync antennas.
7. When operating at night, DO NOT look directly at the spotlight to avoid damaging your eyes.
To Next Page
Loading...
