EasyManua.ls Logo

dji CHX503-7000 - Introduction; Product Overview

dji CHX503-7000
95 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
©
2021  DJI All Rights Reserved.
5
EN
8
10
9
7
6. Charging Cable
7. USB-C Port Cover
8. AC Power Port
9. AC Power Dustproof Cover
10. GND Port
1
3
4
2
6
5
1. Operation Panel
2. Charging Cables Clamp
3. Front Panel Dustproof Cover
4. Charging Cables Storage
5. Handle
13. DO NOT hold the charging cables to carry the battery station. Otherwise, the cables may be
damaged.
14. DO NOT use the battery station in an area where batteries are stored. There should be a
distance of at least 30 cm between the battery station and any charging batteries. Otherwise,
the battery station or charging batteries may be damaged by excessive heating and may even
leadtoarehazard.
15. Keepthebatterystationawayfrominammablematerialswhilecharging.DONOTplacethe
battery station or charging batteries on a blanket or any carpeted surfaces when in use.
16. Foractivationorrmwareupdates,thebatterystationcanbeconnectedtotheDJIASSISTANT
TM
2
for MG or the remote controller of the T10, T30, or T20. Make sure the remote controller has been
updated to the latest version before activating or updating the battery station.
Introduction
The T30/T10 Intelligent Battery Station can connect with up to two batteries. While charging, the
battery station monitors the status of the batteries and can automatically adjust the charging current
if required. The battery station continues to charge even if the ventilation holes are blocked.
Users can check the battery charging status LEDs and the warning indicator on the operation
panelofthebatterystationtoconrmifthereareanyerrors.Thebatterystationcanbeconnected
to a remote controller using a USB-C cable and users can launch the DJI MG or DJI AGRAS
TM
app to check more detailed information regarding any errors. Additionally, the battery station has
the following functions: overcurrent protection, overcharging protection, under-voltage protection,
overheating protection, and status display.
The general descriptions in this user guide apply to both the T30 Intelligent Battery Station and T10
Intelligent Battery Station. The illustrations in this user guide may vary from the actual product. The
T30 Intelligent Battery Station is used as an example below.
Overview
Battery Station

Related product manuals