dji CHX503-7000 - Operation Panel; Panel Indicators and Controls; Mounting the Battery Station

6
©
2021 DJI All Rights Reserved.
EN
1. Charging Status LED × 2
Each LED indicates the charging status
of the battery connected to a charging
cable. The numbers (1-2) correspond to
the position of the charging cable on the
battery station.
2. Warning Indicator
The warning indicator will be on if the battery
station detects any abnormalities. If the
indicator turns solid yellow, connect the
battery station to a remote controller using a
USB-Ccabletoconrmifthereareanyerrors.
If the indicator turns solid red, stop charging
immediately. Only start to charge again once
the indicator is no longer solid red.
3. Power Button
Press to power the battery station on and
off. It is recommended to press the power
button and unplug the AC power cable to
power off the station.
Operation Panel
2 31
Mounting the Battery Station
If the CPX503-3000 switching power supply has not been mounted to the battery station before
leaving the factory, follow the instructions below to mount.
1. Loosen the screws and remove the front panel.
2. Insert the CPX503-3000 switching power supply into the battery station as shown below. The
T30 Intelligent Battery Station has two CPX503-3000 switching power supplies while the T10
Intelligent Battery Station has one.