©
2017 DJI All Rights Reserved.
13
Installation
1. Mount the Antenna Bracket III to the Upper Expansion Plate with four M3.0×6.5 screws.
2. Mount the Quick-Release Top Bracket to the Upper Expansion Plate with two M3.0×6.5
screws.
3. Mount the two GNSS Antennas to the Antenna Bracket III with four M3.0×6.5 screws.
4. Attach the D-RTK Processor (working as the Air System) and the DATALINK PRO Mobile
Station to the Upper Expansion Plate with double-sided tape.
5. Remove the three screws on both left and right sides of the aircraft and mount the Quick-
Release Base Brackets on it.
6. Mount the Quick-Release Top Bracket to the Quick-Release Base Bracket with the knurled
screw.
To Next Page
Loading...
