dji D-RTK - Ground System Installation and Connection; Installation

4
©
2017 DJI All Rights Reserved.
*Complimentary with purchase of both the DJI Matrice 600 and D-RTK.
Ground System Installation and Connection
The following uses the DJI A3 Flight Control System, DJI DATALINK PRO 900 and DJI Intelligent Flight
Battery to illustrate a typical installation and connection.
Installation
1. Mount the DATALINK PRO Bracket onto the Base Board with two M2.5×5 screws.
2. Mount the GNSS Antenna onto the Antenna Bracket
I
with three M3.0×8 screws, and then x the
Antenna Bracket
I
onto the Base Board.
3. Fix the D-RTK Processor onto the Base Board as the Ground System.
4. Fix the DATALINK PRO Base Station onto the DATALINK PRO Bracket.
5. Fix the battery in place with velcro and then x the Base Board onto an appropriate tripod*.
*Supports ordinary camera and camcorder tripods mounted with 1/4-20 screws.
Upper Expansion Plate×1 Bracket×4 Assistant Bracket×2 Antenna Bracket
III
×4
Antenna Clip×2 Screw
M2.5×5
M3.0×8
Matrice 600 Accessories*