Appendix A: Equipment and Setup
The Appendix contains additional details and figures for the RunCam, the Setup
and Help Videos, and the Hardware. Figure 10 shows the Run Cam Layout. Figure 11-
21 show hardware images.
RunCam HD
The RunCam is easy to use. To turn on, press the power button of Cam and the
Indicator A button will flash blue before turning yellow. Pressing the shutter button will
cause the camera to start recording and the Indicator will flash yellow. Pressing it again
and the recording will stop. To charge the camera, use a standard Mini 5-Pin USB cable.
When charging the Indicator will turn green and once fully charged the Indicator will turn
off. Charging takes three hours typically. The MiscroSD will record any footage or
images taken.
Fig. 10: RunCam Layout
To Next Page
Loading...
