7
EN
After the monitor is powered on, wait for a pop-up window that asks for a selection of USB device use, and then select “DJI Pilot”. Otherwise, the app cannot be
connected to the remote controller.
Always set an appropriate RTH altitude before takeoff. Please refer to the Disclaimer and Safety Guidelines for more details.
Ready to Go (GPS)
Before taking off, ensure that the Aircraft Status Bar in the
DJI Pilot app reads ‘Ready to Go (GPS)’ or ‘Ready to Go
(Vision)’ if ying indoors.
5. Flight
Toggle the Flight
Mode switch to
P-mode, the safest
ight mode.
Power on the remote controller,
monitor, and aircraft.
Launch the DJI
Pilot app.
DJI Pilot
App
Manual Takeoff
Combination Stick Command to start/stop the motors Left stick up
(slowly) to take off
OR
Return-to-Home (RC)
Press and hold to initiate the RTH procedure. Press again to cancel.
Manual Landing
Pull left stick down
(slowly) until you touch
the ground.
Hold for a few seconds
to stop the motors.
To stop the motors mid-ight, press
the RTH button while simultaneously
pulling the left stick to the bottom
inner corner. Stop motors mid-
ight will cause the aircraft to crash.
The motor can only be stopped
mid-ight when the ight controller
detects critical error.
Learn more:
http://ysafe.dji.com/no-y
It is important to understand basic ight guidelines for the safety
of both you and those around you.
Refer to the Disclaimer and Safety Guidelines for more
information.
GEO Zones
Rotating propellers can be dangerous. DO NOT start the motors in narrow
spaces or when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still
spinning.
After landing, power off the aircraft before turning off the remote controller.
To Next Page
Loading...
