dji MATRICE 200 series Disclaimer And Safety Guidelines

4
EN
After landing, rst stop the motor, then turn off the Intelligent Flight Battery, and then turn off the remote controller.
When using TapFly™ or ActiveTrack™ features, be prepared to take control of the aircraft by pushing the sticks. Please note that
the aircraft will continue performing the TapFly or ActiveTrack functions after you pushing the sticks. Press the STOP button on
the remote controller or on the screen to exit the such on-going functions completely.
While with advanced technology, the pilot’s sound discretion is required during the ight. Safety and ight assistance features
such as obstacle avoidance, precise landing, and landing protection, are designed to assist your operation, not to replace it.
Environmental conditions including lighting and obstacle’s texture may impact the performance of the Vision System.
Please set the Return-to-Home Altitude higher than surrounding obstacles in the DJI GO 4 app.
Landing protection (detects if the ground is suitable for landing at an altitude of 2 meters above the ground) is used to optimize
the operation experience. Always be alert when in control of the aircraft as the vision system may be disabled in certain situations
(e.g. dim lighting or unclear obstacle surface patterns), and ground surface detection may fail.
5. Maintenance and Upkeep
DO NOT use aged, chipped or broken propellers.
Recommended storage temperature: between 71° and 86° F (22° and 30° C).
Refer to the Intelligent Flight Battery Safety Guidelines for more information about safe use of the battery.
6. Observe Local Laws and Regulations
DO NOT y in the No Fly Zones. You can nd relevant information of these areas at http://ysafe.dji.com/. Please check with local
aviation authorities for a complete lists and regulations of No Fly Zones.
The ight altitude restriction varies in different jurisdictions. DO NOT y above the maximum altitudes set forth in your local laws
and regulations.
Avoid ying in areas where rescue teams are actively using the airspace.

dji MATRICE 200 series Specifications

General

Max Takeoff Weight	6.14 kg
Ingress Protection Rating	IP43
Satellite Systems	GPS/GLONASS
Max Flight Time	38 minutes
Hovering Accuracy	Vertical: ±0.5 m, Horizontal: ±1.5 m
Diagonal Size	650 mm
Charging Temperature Range	5°C to 40°C
Operating Temperature Range	-4°F to 113°F (-20°C to 45°C)