dji MATRICE 200

Mounting the Intelligent Flight Battery
Insert the battery pair.
Press the power button once to check the battery level.
Press once, again and hold to turn on/off.
Only use battery slot B when using one battery to supply power.
Make sure to press the battery remove button when removing the battery.
A
B
Low
High
Learn more:
http://ysafe.dji.com/no-y
It is important to understand basic ight guidelines for the safety
of both you and those around you.
Refer to the Disclaimer and Safety Guidelines for more
information.
No Fly Zones
In the DJI GO 4 App
Watch the tutorial in the DJI GO 4 app or on the ofcial DJI website to learn more.
Always set an appropriate RTH altitude before takeoff. Refer to the Disclaimer and Safety Guidelines for more details.
Gimbal Working Modes More Intelligent Flight ModesAuto Takeoff Return-to-Home (RTH)Auto Landing
5. Flight
Toggle the ight
mode switch to the
P-mode.
Power on the remote
controller and the aircraft.
Launch the DJI GO 4
app and tap GO FLY.
Ready to Go (GPS)
Before taking off, ensure that the Aircraft Status
Bar in the DJI GO 4 app indicates ‘Ready to
Go (GPS)’ or ‘Ready to Go (Vision)’ if flying
indoors.
DJI GO 4
App
Manual Takeoff
Combination Stick Command to start/stop the motors Left stick up
(slowly) to take off
OR
Return-to-Home (RC)
Same as the RTH button in the DJI GO 4 app. Brings the aircraft
back to the Home Point.
Press and hold to initiate the RTH procedure. Press again to cancel.
Rotating propellers can be dangerous. DO NOT start the motors in narrow
spaces or when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still
spinning.
After landing, power off the aircraft before turning off the remote controller.
Manual Landing
Pull left stick down (slowly)
until you touch the ground.
Hold for a few seconds to
stop the motors.
Stop motors mid-ight: Press the RTH
button while simultaneously pulling the
left stick to the bottom inside corner
and hold for three seconds. Only
stop motors mid-flight in emergency
situations when doing so can reduce
the risk of damage or injury.