dji MATRICE 3D Series - Preparing the Aircraft; Inserting the Battery; Powering On;Off and Checking Battery Level

5
EN
Preparing the Aircraft
• Make sure the propellers are securely mounted and not damaged or deformed and
that there are no foreign matter in or on the motors or propellers.
• Make sure the lenses of the vision system, gimbal cameras, the glass of the infrared
sensors, and the auxiliary lights are clean and not blocked in any way.
• Make sure the covers of the microSD card slot, the USB-C assistant port (E-Port Lite),
and the E-Port are firmly closed.
1. Inserting the Battery: Open the battery locking arm and insert the Intelligent Flight Battery
into the battery compartment of the aircraft until a click is heard. Close the battery locking
arm until the orange mark completely disappears, which indicates the battery locking arm is
in the lock position.
• To remove the battery, open the battery locking arms, then press the battery buckles
and remove the battery.
• When transporting an unpacked dock, make sure to remove the aircraft from the dock
for separate transportation.
• If the battery level is too low, charge the aircraft battery by placing the aircraft on the
dock or using a charging kit (sold separately).
2. Powering On/Off: Press, then press and hold.
Checking the Battery Level: Press once.