dji Naza - In The Box; Main Controller (MC); Versatile Unit (VU); Optional GPS & Compass Module

©2012 DJI Innovations. All Rights Reserved. 4
In The Box
Main Controller (MC) ×1
The Main Controller (MC) is the brain of the system, it communicates
with all ESCs and RC transmitter to carry out the autopilot functionality.
It has a built-in Inertial Measurement Unit (IMU) consists of one 3-axis
accelerometer, one 3-axis gyroscope and a barometer for sensing the
attitude and altitude.
Versatile Unit (VU) ×1
Specially designed for Naza. It solves the high power consumption
problem of multi-rotor system, supply and monitor power for Naza and
other electronic devices. It also has an LED to indicate different
operating states of Naza and a USB interface for configuring the Naza
unit and firmware upgrade.
Optional GPS & Compass Module ×1
The GPS/Compass module is for sensing the position and direction.
Optional GPS Bracket ×1
Because the GPS & Compass are sensitive to magnetic interference, you should use this bracket to mount
the GPS module.
USB Cable ×1
This cable is used to configure MC and upgrade firmware.
3-PIN Servo Cable ×8
Cables used to connect the MC and the receiver.
3M Gummed Paper ×4
Used for fixing Naza components on multi-rotor’s frame.