dji Naza - 3 Tx Monitor; STEP1: Receiver Type; STEP2: Cut Off Type

©2012 DJI Innovations. All Rights Reserved. 15
3 Tx Monitor
Notices: I cannot emphasize this Step enough,Make sure you have removed all
propellers before this step!
STEP1: Receiver Type
Choose the type of your receiver. If you use S-Bus receiver, please choose S-Bus compatible option: D-Bus.
If PPM receiver is used, please choose PPM. Otherwise choose Tradition.
Notices:
Please reboot MC and redo the calibration after you change the setup of your transmitter or change your
receiver!
Tips:
If you use S-Bus/PPM receiver, the communication of A, E, T, R, U, X1 and
X2 channels are all through the D-Bus/PPM channel. Right figure shows the
connection of default transmitter channels and MC channels in S-Bus/PPM
receiver (Only first 8 channels of S-Bus/PPM receiver are used at the
moment).
STEP2: Cut Off Type
Please read the introductions of start and stop motor in this step first, and then choose a cut off type.
Transmitter
Channels
MC
Channels
1
2
3
4
5
6
7
A
E
T
R
U
X1
X2