dji PHANTOM 3 PROFESSIONAL

©
2015 DJI. All Rights Reserved.
45
Flight
Phantom 3 Professional User Manual
3. Hold the aircraft vertically, with nose pointing downward, and rotate it 360 degrees around the center
axis. Recalibrate the compass if the Aircraft Status Indicator glows solid red.
If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move your
aircraft to a different location and try again.
Calibrate the compass before each flight. Launch DJI Pilot app and follow the on-screen
instructions to calibrate the compass.
When to Recalibrate
1.When compass data is abnormal and the Aircraft Status Indicator is blinking green and yellow.
2.When ying in a new location or in a location that is different from the most recent ight.
3.When the mechanical or physical structure of the Phantom 3 Professional has been changed.
4.When severe drifting occurs in ight, i.e. Phantom 3 Professional does not y in straight line.
Auto Takeoff and Auto Landing
Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to use the
auto takeoff feature:
1. Launch the DJI Pilot app, and enter “Camera” page.
2. Ensure the aircraft is in P- mode.
3. Complete all steps on the pre-ight checklist.
4. Tap“ ”, and conrm that conditions are safe for ight. Slide the icon to conrm and takeoff.
5. Aircraft takes off and hovers at (1.5 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using Vision Position System for stabilization.
Aircraft will automatically hover below 3 meters. It is recommended to wait until there is sufcient
GPS lock before using the Auto Take-off feature.