as
model
value.
Aircraft complies with FCC/ISEDC
Compliance Information
FCC Compliance Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the use’s authoity to opeate the euipet.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
ISEDC RSS Warning
This device complies with licence -exempt RSS standard (s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
SARtestsar
econductedusingstandardoperating
positionsacceptedbytheFCC/ withthe transmittingatitshighestcertifiedpower
alltestedfrequencybands,althoughtheSARisdeterminedatthehighestcertifiedpowerlevel,
theactualSARlevelofthe whileoperatingcanbewellbelowthemaximum value
Beforeanewmodelisaavailableforsaletothepublic,itmustbetestedandcertifiedto
thatitdoesnotexceedtheexposurelimitestablishedbytheFCC Testsforeach
areperformed
inpositionsandlocations requiredbythe
FCC
ISEDC
/ISEDC,
/ISEDC.
RF Exposure Information
radiation exposure limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC/ISEDC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20cm during normal operation.
remotecontroller
levelin
remotecontroller
theFCC
/ISEDC
For Remote Controller (model GL300L),
To Next Page
Loading...
Need help?
General
Weight and Dimensions
