The joystick on the Tethered Control Handle can be detached. Users can replace the joystick with the extended
joystick.
The Tethered Control Handle can be mounted to other platforms using the cold shoe, 3/8″-16 port, and rosette
mount.
Accessories such as monitors can be connected to the DC OUT port. The CAN Bus port is reserved.
Operation
M Button
Press once to switch user profile.
Press and hold to enter Sport mode.
Press six times to restore the current user profile and the Bluetooth password to default settings.
Trigger
Press and hold to enter Lock mode.
Hold the M button to enter Sport Mode and while held down, press the trigger twice to lock Sport Mode. Repeat
the steps to exit Sport Mode.
Press twice to re-center the gimbal.
Press three times to turn the gimbal 180° so that the camera faces you.
Press four times and hold to begin joystick calibration. During calibration, push and pull the joystick several
times as far as it will go in all directions. Press four times and hold the trigger again to complete calibration. If
the LEDs are blind red, then the calibration has failed. If this happens, repeat the joystick calibration
Press and hold the M button and trigger simultaneously for four seconds to start auto-tune.
Camera Control Button
Press halfway to autofocus, as you would the shutter button on most DSLR
Press once to start or stop recording.
Press and hold to take a photo.
For information on compatible cameras, refer to the Ronin-S Camera Compatibility List on the official DJI website.
Sleep Button
Press once to enter sleep mode, press once again to exit from sleep mode.
Compliance Information
FCC Compliance
To Next Page
Loading...
