26
© 2019 DJI OSMO All Rights Reserved.
Operation Modes
There are three operation modes for the Ronin-SC: Upright mode, Underslung mode, and Flashlight mode.
Roll 360 is available when using Ronin-SC in Flashlight mode. The slip-ring on the pan axis enables Ronin-
SC to perform a continuous roll rotation.
1. To set up Ronin-SC for Roll 360, rst connect to Ronin-SC with the Ronin app. Next, go to the Channels
setting screen (under User Prole, Control, and then Channels) and re-map CH3 to the roll axis (originally
mapped as pan axis) and also set CH1 as N/A to avoid any input on the tilt axis. Afterwards, hold Ronin-
SC in the Flashlight mode and double tap the trigger to re-center the gimbal orientation. Push the
joystick left or right for the gimbal to start rolling continuously. Push the joystick left or right twice to make
the camera rotate automatically. Press the trigger twice to stop the camera from rotating automatically,
and the camera will stop rotating once it is horizontal.
2. To use 3D Roll 360, enter the User Profile screen on the Ronin app, and select 3D Roll 360. When
entering this mode, make sure the camera is not obstructed in any way. Otherwise, 3D Roll 360 cannot
be performed.
Updating Firmware
Update the firmware using the Ronin app. An on-screen alert will be received when new firmware is
available. Follow the on-screen instructions to update the rmware.
Maintenance
Ronin-SC is not waterproof. Make sure to protect it from dust and water during use. After use, it is
recommended to wipe Ronin-SC with a soft dry cloth. DO NOT spray any cleaning liquids onto Ronin-SC.
Upright mode Underslung mode Flashlight mode
To Next Page
Loading...
