dji RONIN-SC - Mounting the Camera

RONIN-SC
User Manual
6
© 2019 DJI OSMO All Rights Reserved.
Mounting a Camera
Make sure to prepare the camera before mounting it to Ronin-SC. Remove the lens cap and make sure
the battery of the camera and memory card are already inserted.
1. The three axes of the gimbal are locked by default. Unlock the three axes, adjust the gimbal to the
position as shown, and lock the three axes again.
2. If required, attach the riser plate* to the bottom of the camera using a athead screwdriver.
1
2
3
2
1
Riser Plate
* Riser plate is required in the following scenarios:
When using a small and lightweight camera such as a Sony A6300 camera.
When using a lens with a large diameter such as a Sony A7M3 camera with a 16-35 mm f/2.8 GM lens.
When used with a focus motor.
3. Attach the dovetail plate and lens support . Move the slider to the front of the plate. The camera
lens and the arrow on the dovetail plate must face the same direction. Mount the camera according to
the indicators on the dovetail plate. USE THE LENS SUPPORT FOR OPTIMAL PERFORMANCE.
Dovetail Plate
1
2
Slider
Lens Support