dji RS 4 - Attaching the Extended Grip;Tripod

DJI RS 4 / RS 4 Pro User Manual
©
2024 DJI OSMO All Rights Reserved.
9
To remove the grip, hold the lever in the unlocked position, press and hold the safety button,
and then pull the grip away from the gimbal.
5
2
3
4
1
5
2
3
4
1
Attaching the Extended Grip/Tripod
1. Attach the extended grip/tripod to the battery grip, tighten, and then unfold the tripod.
2. After removing the foam and protective lm from the axis arms of DJI RS 4 and the silicone
cover from the axis arms of DJI RS 4 Pro, attach the gimbal to the battery grip. Tighten the
grip lever in the locking direction after you hear a "click" to ensure that the handle is rmly
attached.
• DJI RS 4 and DJI RS 4 Pro are installed in the same way. DJI RS 4 is used as an example
below.
• Move the grip lever rmly until no further rotation is possible. The arrow indicates the
direction of locking only and does not represent the fully locked position.