dji RS 4 - Mounting the Camera

DJI RS 4 / RS 4 Pro User Manual
10
©
2024 DJI OSMO All Rights Reserved.
Mounting the Camera
Supported Cameras and Lenses
DJI RS 4 and DJI RS 4 Pro have been rigorously tested to support a payload of 3 kg and 4.5 kg
respectively. Make sure the combined weight of the camera, lens, and other accessories
are within the load capacity. Refer to the official DJI website (https://www.dji.com/support/
compatibility) for the most updated Ronin Series Compatibility List.
Mounting a Camera
Make the following preparations before mounting the camera:
• Remove the lens cap and check that the battery and memory card are inserted in the
camera.
• Make sure to power o the gimbal.
• Unlock the pan axis and rotate it 180°. Move the tilt and roll locks to the unlocked position
respectively and adjust the position of both axes as shown in the gure below, then lock the
axes.
• DJI RS 4 and DJI RS 4 Pro are installed in the same way. DJI RS 4 is used as an example
below.
1 4
5
2
3