Specification
Gimbal: Approx. 1196 g（excl. quick-release
plate and NATO adapter）
Extended Grip/Tripod（metal）：Approx.226 g
Extended Grip/Tripod（plastic）：Approx.226 g
Quick-Release Plate：Approx.102 g
Gimbal (folded): 260 × 210 × 75 mm
Gimbal (unfolded)：400 ×185 ×175 mm (incl.
grip, excl. Extended Grip/Tripod
Model：RB2-3400mAh-7.2V
Type：18650 2S
Capacity：3400 mAh
Energy：24.48 Wh
5V/2A, 9V/2A, 12V/2A, 15V/1.6A
Bluetooth Operating Frequency
2.40 GHz -2.4835 GHz
-20° to 45° C (-4° to 113° F)
14
hours
2
hours（when using a 18
W charger）
FCC Compliance Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
To Next Page
Loading...
