dji RSC 2 - Introduction to DJI RSC 2; Getting Started with DJI RSC 2; Grip and Built-In Battery; Operating the DJI RSC 2

required to launch the Ronin app. Once detected in the list of Bluetooth devices, select DJI RSC 2
and input the default Bluetooth password: 12345678. Make sure you are connected to the internet
and follow the on-screen instructions to activate DJI RSC 2.
Mounting the Camera
Make sure to prepare the camera before mounting it to DJI RSC 2. Remove the lens cap and check
that the battery and memory card are inserted in the camera. Make sure DJI RSC 2 is powered off
or in sleep mode before mounting the camera.
1. Attach the Upper Quick-Release Plate
The camera lens and the arrow on the bottom of the upper quick-release plate must face the same
direction. Attach the upper quick-release plate to the camera by tightening the screw.
2. Attach the Lower Quick-Release Plate and Lens-Fastening Strap
3. Attach the Camera to the Gimbal