dji spreading wings s900

Spreading Wings S900
User Manual
©
2014 DJI. All Rights Reserved.
13
7. Check that every anti-drop screw has been firmly installed in the reserved positions. Thread locker is
recommended.
(1) Remove the anti-drop screws to apply appropriate thread locker.
(2) Replace and tighten.
8. Note that the dampers are 30° silicon rubber. If you use other dampers or vibration absorbing balls, the
quality of your aerial photography may be affected.
Mount the GPS with a bracket to avoid interference from the center frame power board.
Use glue to install the GPS bracket. Ensure it is rm and stable before every ight.
Always test motors using the Assistant Software after installation. Refer to your ight control system
user manual for details.
Mounting Electronics and Wiring
dampers