18
©
2014 DJI. All Rights Reserved.
Assistant Software Installation and Usage
1. Ensure the most recent drivers are installed correctly. This should have been done before using the A2 or
WooKong-M software.
2. Download the appropriate Assistant installer from DJI.com.
3. Double click the Assistant installer and follow the steps to nish the installation.
4. Run Assistant.
5. Upgrade the rmware or congure parameters using Assistant as needed.
The Assistant installer can be used on Windows XP, Win7, and Win8 (32 or 64 bit).
Pre-Flight Check
Ensure the gimbal is properly installed and attached to the landing gear, and that the camera is
mounted correctly and securely.
Before powering on, spin the gimbal through its complete rotation by hand on each axis to ensure
nothing is blocking its movement.
Ensure all cables are connected correctly, without any plugged in backwards or into the wrong ports.
Ensure the AV video power cable is properly soldered and shielded if an AV video transmission module
is used.
Verify TX settings.
Ensure the camera shutter control cable is correctly mounted.
Ensure the camera menu options and settings are correct.
Verify a proper connection between the GCU and the RC receiver.
Verify a proper connection between the GCU and the ight control system.
Ensure the latest Flight Control System Main Controller rmware is installed.
Refer to the Gimbal LED Indicator section in the Appendix to understand the connection status
between the camera and gimbal.
Refer to the Troubleshooting section in the Appendix if an abnormal situation occurs.
Assistant Software Installation and Usage / Pre-Flight Check
To Next Page
Loading...
