3BACK TO MAIN MENU
THE BASICS
HOW DO I START THE OPC566E?
STARTING
1.
Position your Wood Chipper on flat, dry ground.
2. Make sure the fuel shut-o valve is in the “ON” position.
3. Move the choke control lever to the “CHOKE” position (should only be
needed if the engine is cold).
4. Move the throttle control lever to the “FAST” position.
5. Recoil Start: Turn the Ignition Switch to the “ON” position. Grasp the
recoil starter handle and slowly pull until you feel resistance. Let the cord
retract a little bit then pull the cord rapidly to start the engine. One or two
pulls usually starts the engine.
6. Electric Start: Turn and hold the key in the start position until Engine starts
then let the Key return to run position.
7. Move the choke control lever (if used for cold engine) slowly back to the
“RUN” position when the engine is running well.
8. If the Wood Chipper has not been running (cold engine), warm up the
engine by running the engine at half throttle for 3 to 4 minutes, then advance
the engine throttle control to the maximum speed.
To Next Page
Loading...
