DKN EZRUN - Page 8

8
www.dkn-uk.com
STEP 3:
Secure the bottom of the treadmill by using
bolt D12
D21
(M10). Then use bolt D8
washer D21
the treadmill into position.
Note: Do not fully tighten bolts at this
tight for the moment.
STEP 5:
Tighten all the bolts to complete the assembly. Then check that the running belt is running
correctly. To do this, plug the power cable into the mains and turn the treadmill on. Press the
START button. Set the speed to under 3 km/h using the speed keys and check to make sure
that the running belt turns smoothly.
Note:
moment.
STEP 4:
Place the bottle holders B49 into the
bottle holder bases, place the safety
key C13 into position on the console,
and plug the power cable C15 into the
socket at the base of the treadmill.
DO NOT STAND ON THE TREADMILL WHILE CARRYING OUT THIS TEST!
Your new treadmill is now ready for use!
D12
D21
D21