Web Power Switch Pro
digital-loggers.com
4
Important Factory Defaults
IP: 192.168.0.100
User name: admin
(lower case)
Password: 1234
To reset to factory defaults, gently
press the reset-to-defaults button
below the LCD to enter the reset
menu, then select a reset option.
Quick Setup
Use these shortcuts if you are an experienced installer. We recommend
reading the entire manual for rst-time installation.
• Unpack. Save the carton. Attach the line cord. Power up.
• Attach an Ethernet cable from the controller to your LAN. Switch power
on. If you are attached through a switch, you may need to power-cycle
your switch to initially establish a connection.
• Ping the default address 192.168.0.100 to conrm that a network
connection is established. If you don’t receive a response, proceed to the
IP Setup section below.
• Log in to the Pro using the default user name admin and the password
1234 Note: “admin” must be entered in lower case.
• Click the Settings link to reach the conguration page. Select the safest
power-loss conguration for your installation: (all OFF, all sequential ON,
or pre-powerloss sequential ON) Note that pre-powerloss means the last
previously congured state, and it does not take cycling into account.
“Power loss” is dened as loss of AC power for more than 100ms.
• Congure the Pro as described below. After each change, click Submit
and wait for the page to refresh before continuing.
Tip: A three-bulb electrical safety-tester is handy for checking
conguration before attaching loads.
To Next Page
Loading...
General