6 | DLO TRANSDOCK MICRO USER GUIDE
| 7
Using Your DLO TransDock micro
6. Match the FM frequency on your TransDock micro with the empty FM sta-
tion on your radio using the Tuning Buttons on TransDock micro (Right
Button for tuning up, Left Button for tuning down). Most of the static will
go away. Now your radio has found TransDock micro’s signal.
7. To control the overall volume of your music while using TransDock micro,
use the car radio’s volume control, not the Sansa volume.
About TransDock micro FM Transmitter
TransDock micro is basically a mini radio station that broadcasts your Sansa
music to the FM radio in your car, while charging the battery in your Sansa at
the same time. TransDock micro has two Tuning Buttons on either side, so you
can tune to any frequency from 88.1 to 107.9. It comes with four preset sta-
tions, so you can set it to the frequencies you use most.
Setting Up Your TransDock micro
1. Turn on your car radio and set it to FM radio mode.
2. Slip the Fit Collar onto your TransDock micro to ensure a secure fit in your
car’s cigarette lighter or 12v power outlet.
3. If you want to change the angle of your TransDock micro for the easiest
access, loosen the Adjustment Screws and adjust TransDock micro to the
best position.
NOTE: It may help to remove TransDock micro when you do this. Unplug
TransDock micro, adjust and plug back in.
4. Plug the Connector Cable into TransDock micro’s USB Connector Dock.
Plug the other end of the Connector Cable into your Sansa.
5. Find an FM frequency with no signal or radio station. For more help with
this, please read Finding Empty Radio Frequencies [pg 8].
To Next Page
Loading...
Need help?
General
