DLO TransDock micro User Guide

8|DLO TRANSDOCK MICRO USER GUIDE
| 9
Setting Preset Stations on Your TransDock micro
To set your own preset stations, follow these simple steps:
1. Using the Left and Right Tuning Buttons, tune TransDock micro to the sta-
tion you’d like to set.
2. Press and hold both Tuning Buttons simultaneously for three seconds to
save that station as a preset station. The display on TransDock micro will
flash the preset station you just set, e.g., CHO1, CH02, CH03 or CH04.
3. To add a second preset, cycle to another preset station by briefly pressing
both Tuning Buttons at the same time and repeat steps 1 and 2.
NOTE: Your new preset will override whatever preset was last saved.
4. Repeat steps 1 and 2 for preset station 3 and 4 to set all four TransDock
micro presets.
Getting the Best Sound Quality
• Make sure the frequency you’ve tuned to is empty and not near a strong
station. A good place to start is channel 88.5, which is the default frequen-
cy on TransDock micro and often empty.
• TransDock micro will tune to any radio frequency, from 88.1 to 107.9, so
try the entire spectrum until you find an unoccupied channel. To learn
more, please read Finding Empty Radio Frequencies [pg 8].
Finding Empty Radio Frequencies
If you live in a big city with a lot of FM radio stations, finding an empty FM
frequency can be tricky. Visit www.dlo.com/openfm to find the best frequen-
cies in your area.
Here are some tips for finding an empty station:
• Be sure to search the entire spectrum of FM frequencies, from 88.1 to
107.9. Don’t just look to the low end of the dial. There are often empty
FM stations in the 100’s that will work great.
• When using scan/seek on your car’s radio, if your tuner stops on 101
and then jumps to 103, look in the 102 frequencies for empty stations.
• Try tuning to a strong station, then backing down two frequencies - for
example 103.5 to 103.1. You can often find empty frequencies this way. If
that frequency is taken, scan to the next station and try again.
• Save a station as a preset on your radio when you find a frequency that
works well in your area, and also set that frequency as a preset on your
TransDock micro. To learn how to set a preset, please read Setting Preset
Stations on your TransDock micro [pg. 9].
Tuning Your TransDock micro
To tune your TransDock micro, use the Tuning Buttons on either side of the
unit – Right Button for tuning up, Left Button for tuning down.
TransDock micro has four preset stations. The default presets are 88.1, 94.9,
100.9, and 107.9. To cycle through these presets, briefly press both Tuning
Buttons at the same time.
T R A N S D O C K MI C R O

DLO TransDock micro Specifications

General

Brand	DLO
Model	TransDock micro
Category	Automobile Accessories
Language	English