Installation
Before you begin installation
Before you begin you need to read the manual, to have
some tools, cables and other material available. There
is one such list of material on the following page.
Amplifier location
Important
Allow air circulation around the amplifier.
2
Disconnect Battery
Before starting the instal-
lation, always disconnect
the negative terminal of
the battery.
The Reference series of amplifiers have a compact
design that allows great flexibility in mounting. You
can mount it under a seat or in the trunk.
When you select a location, do remember that the
amplifier generates a lot of heat.
Choose a location where air can circulate freely
around the amplifier. Do not cover the amplifier with
carpets or hide behind trim panels.
Do not mount the amplifier in an inverted or upside
down position.
Check all locations and placements carefully before
making any cuts, drilling any holes or making any
connections.
DLS logo on amplifier cooling flange
The DLS logo on the amplifier top is attached with
two small screws. The logo can be removed and
twisted 90 or 180 degrees, and then screwed back
in wanted position. The logo can be mounted in
four different ways to match your installation.
Mounting
IMPORTANT!
Use the metal screws coming with the amplifier
when you do the install. Do not use oversized
screws, you may destroy the plastic ears by
doing so.
The RM15, RM30 and RM40 has a cooling fan built-
in, make sure that the air can circulate freely aro-
und the fan opening.
Features:
w RCA inputs
w High level inputs
w Continously variable high pass and/or
low pass crossovers
w Bass EQ / SUB EQ function (only RM10,
RM15 & RM20)
w Remote start
w Automatic remote start on high level inputs
without the use of remote wire
w Electronic protection circuits against
short circuit, DC offset and high temperature
Bridge mode capability on the stereo
amplifiers
We follow a policy of continuous advancement in
development. For this reason all or part of
specifications & designs may be changed without
prior notice.
To Next Page
Loading...
Need help?
General
