5. TROUBLESHOOTING
5.1 SOFT RESET
If your PACKTALK SKI stops responding, reset it in one of these ways:
● Turning it off and then on again (see Getting Started on page 5).
● Using the supplied USB cable, connect your unit to the computer or wall charger for 30 seconds.
5.2 RESET TO FACTORY SETTINGS
This option deletes all paired units, devices and all configuration settings.
To perform a factory reset through the unit:
1. Check that your PACKTALK SKI is in Standby mode (see LEDIndications on page 14).
2. Simultaneously press + + for 5 seconds.
The LED flashes purple 5 times slowly, confirming that pairing has been reset.
5.3 FAQ
Additional answers to common problems can be found at https://www.cardosystems.com/support/packtalk-ski-
support/.
12
To Next Page
Loading...