- 6 -
1.8 Electrical shock hazard
If done incorrectly, attempting to disassemble or repair, there is a risk of electric shock.
Contact service only by a qualified service organization.
(1) It must be connected to the correct earth contact type socket on this product.
(2) Install the system where it will not come in contact with water or other liquids.
(3) Install the system in a place protected from rainy weather or weather.
(4) Electrically ground the system. Failure to follow these instructions can result in death,
fire, or electric shock.
1.9 Do not use this product in or near area where it can fall or be pulled into water or other
liquids. If moisture enters the motor, it may cause malfunction of the motor
1.10 Do not reach for this product if it has fallen into liquid. Unplug immediately. Water may
cause a short circuit which may result in an electric shock.
1.11 Never operate this product outdoors in the rain or in a wet area. All electrical products
can be electrocuted by moisture.
1.12 Do not use in places where there is a risk of explosion or fire
Do not use this equipment in or near explosive atmospheres or where aerosol (spray)
products are being used. There is a risk of explosion or fire in case of motor
overheating in the firearm area.
-------------------------------------------- --------------------------------------
Do not use this product near flames
Electromagnetic Compatibility
EN 61000-6-2:2005, EN 61000-6-4:2007/A1:2011, EN 61000-3-2:2014,
EN 61000-3-3:2013 Standards governing Electromagnetic Compatibility
To Next Page
Loading...